20*20mm Zeez F7 2020 FC MPU6000 5V/3A BEC 6UARTS OSD 3-8S Flight Controller with Type-C RGB 128MB 8S input for FPV Racing RC Drone

Specifications
-Mounting Holes 20*20
-Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
-Up to 8S input (max 36V)
-5V BEC up to 3A continuous
-STM32F722 MCU (Support Betaflight, INav, Emuflight)
-MPU6000 Gyro/ACC for smooth performance
-128MB Onboard flash
-OSD chip Onboard
-6 available UARTS
-VTX switch to control the ON/OFF of the VTX
directly from your transmitter (control via Betaflight with USER1 mode)
-LC Filter for 5V VTX and Camera
-USB Type C connector
-Onboard RGB LED distribution for clean wiring
to the LED on the arm of the quad.
-8 Onboard RBG LED (compliant with FAI Rules)
-Logic Side and USB current protection
Features
-Support up to 8S input with 5V @3A BEC (protected from over current, over temperature and short circuit) for power all peripherals. (such as CAM, VTX, LED, RX)
-Build with STM32F722 MCU for best performance, it support all most used firmware on the market, like Betaflight, EmuFlight and INAV.
-MPU6000 Gyroscope and accelerometer combined with soft mount will give you the best clear signal that will track your motion.
-Onboard 128MB flash to store all logs for days of flight.
-VTX switch to power ON/OFF your video transmitter directly from your radio (enable it using USER1 in the modes tab of the firmware) .
-OSD Chip with all correct capacitor and LC filter will give clear voltage to the camera and the VTX.
-Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
-USB type C connector and logic side current protection built in to save the FC from short.
-8 RBG onboard on the side of the board to light up you drone in competition or if you are flying freestyle.
Zeez F7 2020 includes
(1X) Zeez F7 2020 Flight Controller
(4X) Aluminum Standoff
(4X) Aluminum Nut
(1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
(1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) JST SH 1.00mm connector
(1X) JST SH 8 Pin Plastic Housing
(1X) JST SH 10 Pin Plastic Housing
(2X) 2.00mm Header Pin for VTX connection
(2X) 2.54mm Header Pin for Receiver connection
(2X) Spare M3 rubber anti vibration for Flight Controller or ESC