The BeecoreX is a ultimate flight controller for Brushed Tinywhoop , it include F4 FC, vtx , ESC, frsky receiver and betaflight OSD.
It makes very easy to build a brushed tinywhoop.
You only need to buy an FPV camera and brushed motors ,frame and propeller and then plug and play ,
No soldering require at all .
Item Name:BeecoreX FR F4 1S Flight Controller
Flight Controller:(Frsky SPI RX version) Betaflight Firmware Target:CrazybeeF4FR
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Board Size:28.5 * 28.5mm
Power Supply:1S Battery Input (DC 2.9V-4.35V)
Built-in 5A(each) Brushed 4IN1 ESC
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX 25mw~100mw Switchable
Built-in SPI Frsky receiver(compatible with Frsky_D/ Frsky_X/ S- FHSS/ Redpine protocol)
Built-in 5V 1A BEC
Built-in voltage detection
Onboard Frsky SPI Receiver Version:SPI BUS receiver Frsky Version
Compatible with Frsky D8/D16 ( D8 is Recommend) , S-FHSS , Redpine Protocol
No Ground Interference ( Transmitter and receiver 1 m from the ground):100m~200m
Onboard 5.8g VTX:Output Power:25mw~100mw Switchable
Input Voltage:3.3V 5.5V
Frequency:5.8GHz 5bands 40 channels
With Race Band
VTX POWER=1 (25mw)
Recommend to use 50mw.
Recoomend Runcam Nano3 camera , plug and play.
(No Included Runcam Nano3 Camera)
R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input.
IR1(IRX1) Pad is used for SBUS signal input (Already inverted).
R1 and IR1 Cannot be used simultaneously.
1x Happymodel BeecoreX FR F4 1S Flight Controller
1x Cable with Conenctor
1x Conenction Cable
4x Anti-Vibration Standoff
1x bag of Screws
Happymodel BeecoreX FR Brushed F4 OSD 1S Flight Controller Built-in 5A Brushed 4IN1 ESC 5.8G 25-100mW VTX SPI Frsky RX for Brushed Tiny Whoop FPV Racing Drone
Shipping:Standard Shipping about 10-25 business days