Ardupilot Arduplane Pitot Analog Airspeed Sensor for APM Pixhawk Flight Controller

SKU: RC1428589

$28.66

Ship From:China
Dispatch:Ship between 2 bussiness days
Payment Methods:Paypal & Credit Cards and more >Buyer Protection:
Full Refund ,If you do not receive your order
Full or Partial Refund , If the item is not as described more >payment

Share:
Size

Recommended for You

Description

Ardupilot Arduplane Pitot Analog Airspeed Sensor for APM Pixhawk Flight Controller
Specification:
Item Name: Analog Airspeed Sensor
Version: APM Version / Pixhawk Version ( Optional)
APM Version is compatible with APM Flgiht Controller
Pixhawk Version is compatible with Pixhawk Flight Controller
Analog Airspeed sensor
The way this airspeed sensor works is that the top tube is “active”
(measures air pressure from the pitot tube that is open at the front and has air driven into it by airspeed)
and the bottom one is “static” (measures ambient air pressure from tube with intakes on the side).Connect the active sensor port using silicon tube to the straight tube exiting from the rear of the pitot tube.
The angled tube is the static part connecting to the static port of the sensor (the port on the sensor closest to the PCB)
APM/Pixhawk Analog Airspeed Pin and Wiring
1. For Pixhawk
– The “airspeed” pin 15 is located on a 3 pin DF13 connector on the Pixhawk board.
– This pin can take voltages up to 6.6V (it has an internal voltage divider).
– The air pressure connector (labeled ADC 6.6V) is a 3 pin connector on the top right of the Pixhawk.
– Wire the airspeed sensor’s signal wire to pin 2 (the center pin) of the connector.
– Wire pin 1 (towards the center of the board) to the sensors VCC (5 volts) input.
– Wire pin 3 (nearest the edge of the board) to the airspeed sensors ground.
– Assign the airspeed sensor to an appropriate “PIN” in Mission Planner – Configuration – Advanced Params – Adv Parameter List.
– Set the ARSPD_PIN parameter to 11 in the Advanced Parameter List and select “Write Parameters”.
2. For APM
– Plug it into the pins on the “A0” port.
– Assign the airspeed sensor to an appropriate “PIN” in Mission Planner – Configuration – Advanced Params – Adv Parameter List.
– Set the ARSPD_PIN parameter to 11 in the Advanced Parameter List and select “Write Parameters”.
Package Content:
1x Airspeed sensor Module
1x APm or PIXHAWK wire
1x 3D Pringing Pitot Tube

Order Note:Order this product,please provid the option as follows to order notes on checkout page.
Mode APM version/Mode PIXhawk/

Reviews

There are no reviews yet.

Be the first to review “Ardupilot Arduplane Pitot Analog Airspeed Sensor for APM Pixhawk Flight Controller”

Payment Methods:


1.Paypal
paypal

2.Credit Cards
payment
Know more payment methods,[click here]!

Shipping Methods:


shipping-methods
When you place your order at rcbuying,we will choose the right shipping mothods to ship the package to you,such as EMS,DHL,UPS,Fedex,China airpost and others,know more [click here]

New Arrivals