Happymodel Bassline 2S 90mm 2 Inch Micro Toothpick FPV Racing Drone BNF with CADDX ANT 1200TVL Camera
Introduction:
Introduce the Bassline , inspired from Our team pilot Nathan Loopz . This ide Awas originally born in 2019, and today make it into ABNF.
Even though we have many excellent Micro Freestyle drones now days, but the Bassline’s performance is still the craziest.
Manual:
ELRS Version ; Frsky Version ; PNP Version
Features:
X12 5-IN-1 AIO flight controller built-in 2.4G ELRS V2.0 and OPENVTX
VTX Power up to 400mw
Support ELRS V3.0 (Need to upgrade firmware)
Powerful EX1103 KV11000 motors
CaddxFPV Ant FPV camera
Recommend battery (Not include):
2S 350mah/450mah/550mah/650mah
, Battery tray size: Maximum
support for batteries with a width of approximately 17mm and a height of
approximately 13mm
Specifications:
Brand Name: Happymodel
Item Name: Bassline 2S 2inch Micro FPV toothpick droneWheelbase: 90mmSize: 115mm*115mm*40mm
Analog version Weight: 40gram
Optional Receiver version:
2.4G
ELRS SPI /
SPI
Frsky D8/D16 /
SPI
Flysky /
PNP
(without onboard receiver)
Spare parts specifications:
| Motor | Mode: EX1103 KV11000 Configu-ration:9N12P Stator Diamter:11mm Stator Length:3mm Shaft Diameter:??1.5mm Motor Dimension(Dia.*Len):??13.5mm*15.5mm Weight(g):3.8g No.of Cells(Lipo):1-2S |
| Propellers | Weight:0.88g Material: PC Pitch:2.3inch Props Dia:52.17mm Center Thickness:5mm Center Hole Dia:1.5mm |
| Flight controller | X12 ELRS V2.1 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280 X12 Frsky V2.1 flight controller built-in SPI Frsky 2.4G receiver Target: CRAZYBEEF4FR X12 Flysky V1.0 flight controller built-in SPI Flysky 2.4G receiver Target: CRAZYBEEF4FS X12 PNP V1.1 flight controller without onboard receiver Target: CRAZYBEEF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: ICM20689 or ICM42688P(SPI connection) Mount hole size: 25.5mm*25.5mm Power supply: 1-2S battery input (DC 2.9V-8.7V) Built-in 12A(each) Blheli_S 4in1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G OpenVTX 0mw~400mw Built-in ExpressLRS 2.4G,Frsky D8/D16,Flysky AFHDS 2A Built-in voltage detection Built-in current sensor |
| Onboard 4in1 ESC | Power supply: 1-2S LiPo/LiPo HV Current: 12A continuous peak 15A (3 seconds) Support BLHeliSuite programmable Default Factory firmware: Z_H_30_REV16_7.HEX Default protocol: DSHOT300 Support Bluejay firmware |
| Onboard SPI ExpressLRS 2.4GHz Receiver | Packet Rate option: 50Hz/150Hz/250Hz/500Hz ExpressLRS Firmware version: V2.0 RF Frequency: 2.4GHz Antenna : SMD antenna Telemetry output Power: <12dBm Receiver protocol: SPI ExpressLRS Compatible with ExpressLRS V2.0 TX Module Couldn??t flash separately ExpressLRS firmware Could flash FC firmware to support ExpressLRS v3.0 TX module |
| Onboard SPI Frsky D8/D16 receiver Version | SPI BUS receiver Frsky D8/D16 compatible Compatible Non EU transmitter D8/D16 model Channels: 8ch/16ch No ground interference ( Transmitter and receiver 1 m from the ground): 200meter Failsafe support |
| Onboard SPI Flysky receiver Version | SPI BUS receiver Protocol: AFHDS-2A Channels: 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 200meter Failsafe support |
| PNP Version (without onboard receiver) |
Full UART1 for external Receiver Support CRSF/GHOST/SBUS/IBUS/DSMX protocol IR1 pad(invert RX1) used for SBUS input |
| Onboard 5.8g OPENVTX | Firmware version: OPENVTX Smartaudio v2.1 PIT Mode support RCE Mode support Channels:48ch Transmitting Power: 0/RCE/25mw/100mw/400mw Power supply: DC 5V Current (5v): <650ma (400mw) |
| Caddx ANT 1200tvl camera | Image Sensor: 1/3′ CMOS Sensor Horizontal Resolution: 1200 TVL TV System: NTSC or PAL IMAGE: 16:9 or 4:3 Synchronization: Internal Electronic Shutter: PAL: 1/50~100,000; NTSC: 1/60~100,000 S/N Ratio : >52dB (AGC OFF) Video Output: CVBS Lens: 1.8mm Min. Illumination: 0.001Lux@F1.2 Auto Gain Control: YES WDR: Global WDR DNR: 3D DNR Dimensions: 14*14mm(with bracket to 19*19mm) Wide Power Input: DC 3.7-1 |
A7C -
I had to wait longer than expected, but the product is decent.
ARpw -
I had some initial difficulties with the product, but the customer service staff were a lifeline.
77SUh -
The product arrived sooner than expected, and it's wonderful.
Maggie -
I'm constantly singing the praises of this product.
futzUIL -
This product, Happymodel Bassline 2S 90mm 2 Inch Micro Toothpick FPV Racing Drone BNF with CADDX ANT 1200TVL Camera, has improved my life significantly.
Lacey -
Fast shipping, and the product is exactly as described.
Una -
Initially, I was confused about the product's features, but the customer support clarified everything.
Warlike -
The quality of Happymodel Bassline 2S 90mm 2 Inch Micro Toothpick FPV Racing Drone BNF with CADDX ANT 1200TVL Camera is impressive. Highly recommended!
Admirable -
I've recommended this to all my colleagues.
JyBRMoXE7 -
This product, Happymodel Bassline 2S 90mm 2 Inch Micro Toothpick FPV Racing Drone BNF with CADDX ANT 1200TVL Camera, is simply outstanding.
CgPXk9m -
The surprise gift was a pleasant surprise that demonstrated the seller's commitment to excellence.
9n8ycN -
The product meets my expectations, despite the slow shipping.
HEsV -
The product meets my expectations, despite the slow shipping.
lwWgU9yf -
I'm constantly telling my friends how great this product is.
Zachariah -
Happymodel Bassline 2S 90mm 2 Inch Micro Toothpick FPV Racing Drone BNF with CADDX ANT 1200TVL Camera has made my daily life so much better.
UAE -
The surprise gift was a delightful surprise that added a personal touch to my purchase.
Keely -
After thorough online research, RCBuying was the only choice that made sense for this purchase.
Mary -
I'm impressed by the exceptional customer service at RCBuying.
Quintessa -
I wish I had found this product sooner. It's a game-changer!
BCyYhBsR -
I've never left a review before, but this product deserves it.